Acecad DigiMemo 692 Betriebsanweisung PDF herunterladen (Seite 9)

Pen Cap Ink Cartridge

Pen Clip Front Section Barrel

Barrel Cove

Rear Section

(-) Cap

(+) Can

Battery

Compartment

not be turned on to capture and store your handwriting.

Installing the Battery into the Digital Inking Pen

Unscrew the barrel cover counterclockwise from the barrel of

the pen. Take out the button cell battery (SR626SW, 377 or

IEC-SR66) that is included in the package of the DigiMemo

A502/692. Insert the battery into the battery compartment with

the negative (-) cap facing the battery compartment. Screw

the barrel cover clockwise onto the barrel until tight.

Note! Incorrect battery installation will result in the

malfunction of the digital inking pen.

Note! The battery of the digital inking pen will last

approximately 14 months.

Note! The front or rear section of the pen can hold

the pen cap.

Note! You can attach some cord or accessory to

the pen through the two holes on the pen

end.

Note! You can clip the pen to the pad by using the

pen clip to clip to the right or left pen holder

of the pad.

Putting a Notepad or Paper on the Digital Pad

To hold a notepad on the pad, slide the backing of the notepad down into the notepad

slot on the pad as far as the backing can possibly go.

Note! The size of the notepad holder on the

pad is 6.0" x 9.1" (153 mm x 232 mm).

Your notepad size can not be over this

size.

You can directly put a few sheets of paper on

the writing area of the pad for your writing. You

also can use the paper clip to clip a few sheets

of paper on the pad for your writing.

Pen End

Paper Clip

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Keine Kommentare

Acecad DigiMemo 692 Betriebsanweisung Seite 9